Door Phone 2N

A doorphone is a common device to configure on our platform. These can’t be provisioned and must be configured manually.

Some doorphones from 2N come with video. The phone devices supporting Video in our gamma are the Yealink T49, T58A/W and Grandstream GXV 3XXX.

Important notice : The video stream is only visible on the phone once the call has been answered. 

First create a device of the type PC / Tablet.

Go to the credentials Tab and copy the Realm, username and password.

After this, configure the doorphone by opening a webpage to the local IP address of the device. Login to the device with the default credentials :

• username : Admin

• password : 2n

Once on the login page, choose the Services in order to configure the SIP account. Fill in the fields like below. Note that the transport is set to UDP on port 10060.

Modify the local SIP port to a value above 1024.

If you want to be able to call the doorphone please set the Call Answering mode to Automatic.

Don’t forget to also create a callflow and assign a number to it.

Go to the Directory page to configure the number the doorphone will call. This number must also exist in your callflow  and direct the recipient of the call.

Go to the hardware page to configure the buttons. This will allow the doorphone to make the call like configured in the call flow on the portal.

Verify that the codec settings are selected like here :

Here you configure the code to open the door. In this example the code = 12.

Make sure the electrician installed a 12 v or 24 v power supply to the door relay.

Activate Legacy switch code, to avoid having to use “*” before the number code to open the door.